Large Scale Central

Isn't it about time for the MIK?

The MIK - Annual Build Challenge
#11

LMAO … bump for post count

#12
1 Like
#13
1 Like
#14

Time to start doing incantations around my old foe Table Saw to see if I can propitiate the beast accomplish the fabled “straight cut!”

1 Like
#15

i was just thinking about the challenge and realized I have not seen Dave post in a long time. Does anyone know where he is? Actually a little worried about him.

#16

He has posted since the software change.

#17

Remember …one ping only

#18

The challenge is always fantastic in my opinion !

1 Like
#19

‘C’ clamps help with that.

1 Like
#20

@Devon_Sinsley I just replied to the last thread Dave posted in on October 21.

1 Like
#21

He messaged me the other day about getting into the site but I haven’t heard back from him.

1 Like
#22

Well I am not gonna lie, at this point I don’t even care about the challenge, With Dave’s recent past health issues I am more than a bit worried about him. Very unusual to not have heard from him by now and his last post being back in October is not normal. I sent him an email so hopefully I will hear back. If anyone has heard from him recently or has a means of getting a hold of him, It would sure put my mind at ease knowing he is okay.

1 Like
#23

@Devon_Sinsley did you see Dave’s post about MIK 2022 being 4 days away?

1 Like
#24

Yes read with a sigh of relief at an answered prayer.

#25

Where’s Dave’s post??, I can’t seem to find anything on this site anymore.

1 Like
#26

He posted on the general forum

1 Like
#27

Thanks Devon I found it :slightly_smiling_face:

1 Like
#28

Tomorrow, yippie. Its almost upon us. . . What will Vic. . . I mean I make?

#29

I think its Jan 1st in China. Can we start?

#30

If you are in China, go ahead :stuck_out_tongue_winking_eye:

1 Like