Loco has two motor block and is run analog only.
Seems to run ok analog.
PB11 sound card is dead.
I removed the PB11 and connected a new one
Directly onto the track. Works ok, but when I put the loco on the track and the sound stops.
I connected my RRamp meter to the track and when I start the loco the AC light comes on.
Any ideas what is up?
David
This is DCC power?
Did you set the DCC address of the PB11?
Greg
Greg,
“Loco has two motor blocks and is run analog only”. (no decoder).
Using my LGB 6amp power supply and LGB controller.
For some reason the RRamp meter flashes “AC” when I start the forney
And the sound cuts out.
David
Does the loco move properly when the AC light flashes or does it stop?
Greg