Forums Power and Sound Power and Sound DCC
  • Topic: Bachmann #91199 2-4-2 decoder

    Back To Topics
    (0 rates)
    • October 7, 2017 6:11 PM EDT
      • Peeples Valley, Arizona
      • Posts
      • Thanks
      • Thanked

      Bachmann #91199 2-4-2 decoder

      I'm still considering picking up a Bachmann 2-2 "Lyn" loco. It is labelled DCC-ready. What decoders would be appropriate for this loco, and how do you install/set it up?

    • October 7, 2017 7:36 PM EDT

      • Posts
      • Thanks
      • Thanked

      "DCC Ready" means that the loco is wired such that all of the features of the loco (motor, lights, smoke, etc.) are controlled from a central location. On the 2-4-2 (according to Bachmann's documentation), it has the NMRA-standard 8-pin connector on this board. Installing a DCC decoder would be as simple as plugging in any DCC decoder into this socket via an 8-pin plug.


      Bachmann DCC installation diagram


      As for which decoder, that's up to you (though something with a diesel sound might raise eyebrows). This being a small loco--presumably one that's not going to be pulling heavy trains, I'd think one of the smaller decoders rated at between 1 and 2 amps would be more than ample. ESU, Zimo, Soundtraxx, TCS--they all have suitable decoders. The decoder may be available pre-wired with an 8-pin connector, or you may be able to buy an adapter harness for some. You could spend the extra money on the higher-capacity decoders, but they're definitely not going to have an 8-pin connector wired to them, and they may not fit inside the boiler of the loco.





      This post was edited by Kevin Strong at October 7, 2017 7:39 PM EDT
Forums Power and Sound Power and Sound DCC

    Icon Legend

  • Topic has replies
    Hot topic
    Topic unread
    Topic doesn't have any replies
    Closed topic
    BBCode  is enabled
    HTML  is enabled

Add Reputation

Do you want to add reputation for this user by this post?

or cancel

Ads by Google