A few people have been PM’ing me about how i’m doing the Gp-30 project, which is almost done, so I will try to document how I started the project with this one
Obviously it starts with a prototype
Existing drawings do help
i can insert the drawing in sketch up 2014 and trace the image and then size the tracing to scale
from there I can start with a frame (It’s a 3d drawing however it is no where near ready to send to a 3d printer at this point) This is only a line drawing of a 3d model if that makes sense
Now that I have a basic drawing almost done (I have the roof still left to do before this can happen) , I will rip this 3d model apart and make the pieces 3d printable,
