Forums Power and Sound Power and Sound
  • Topic: Interesting Problem With an AristoCraft Train Engineer

    Back To Topics
    (0 rates)
    • June 9, 2018 3:43 PM EDT
      • Santa Ana, CA
         
      • Posts
        1,377
      • Thanks
        1
      • Thanked
        66

      Interesting Problem With an AristoCraft Train Engineer

      I run three AristoCraft Train Engineers (TE).  These are the somewhat later 27 mHz, 10 amp units with the later transmitters.  Each is powered from a Meanwell 24 volt, 12.5 amp power supply throttled down to 22 volts.  The system is set up using sp3t block switches to select any TE to any of 23 blocks of track.  The system also runs a common ground between the three TEs and the a/c and halfwave d/c for the accessories, turnouts, and lighting.

       

      Lately one of the TEs (Cab 3) developed an interesting problem.  It works fine until I switch Cab1 into the control panel, even if Cab 1 is turned off. Then Cab 3 goes to 0 volts and looses its programming.  I can reprogram it and it works fine again, until I switch in Cab 1.

       

      I can switch in Cab 2 and Cab 3 does not react like this and continues to work normally.  This could then indicate a problem (high resistance short or such) in the panel between Cab 1 and Cab 3.

       

      But, if I trade out Cab 3 for different AristoCraft TE, everything works fine just as it should, indicating the panel is fine and the problem is in the TE.

       

      Again..., it works fine and keeps its programming as long as I don't switch in Cab 1, even if none of the block switches are selecting Cab 1.  If I unplug the TE for Cab 1 from the panel and switch it on, Cab 3 continues to react normally.

       

      At this point, all I can think to do is to check those capacitors on the board that are easily removable.  If they all look good, I'll guess I'll just have to get rid of the unit unless someone has some other ideas.

       

      Thanks

      This post was edited by Todd Brody at June 9, 2018 3:45 PM EDT
    • June 9, 2018 9:39 PM EDT
      • Pittsburgh, Pennsylvania
         
      • Posts
        9,602
      • Thanks
        65
      • Thanked
        506

      So Cab 1 is "talking" to cab 3 and resetting it. Shouldn't they be on different channels?

      ____________________________________

      Shannon car Shops
      Home of the infamous leg lamp

      I.A.R.R.R. Member #12

      and King Butt Modeler

    • June 10, 2018 1:54 AM EDT
      • Santa Ana, CA
         
      • Posts
        1,377
      • Thanks
        1
      • Thanked
        66

      They are on different channels.  It is not that they are "talking" but more like Cab 1 "interupts" Cab 3 by its very presence in the system.

       

      After open house this and next weekend, I may try using the Cab 3 TE in the Cab 2 position and see if the problem persists.  Meanwhile, another TE is substituting and seems to work fine in this position.

Forums Power and Sound Power and Sound

    Icon Legend

  • Topic has replies
    Hot topic
    Topic unread
    Topic doesn't have any replies
    Closed topic
    BBCode  is enabled
    HTML  is enabled

Add Reputation

Do you want to add reputation for this user by this post?

or cancel

Ads by Google